Why Does My Garage Door Track To One Side

Misaligned tracks misaligned tracks are another common cause for a garage door going off track.

Why does my garage door track to one side.

With misaligned tracks the risk of the rollers coming off the tracks gets much higher. It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw. I have no overhead garage door one third horsepower. The front measured 15 and the back measured 16 from the wall.

With the door propped open take the s hook out of the support and tighten or loosen the cable as needed. Bottom of the door is up on one side. The cable is attached to the door and runs to an s hook that attaches to the track support. I had a garage door company here that told me my garage door needs to be balanced and showed me how it would not stay up by itself when door is not engaged.

The vertical tracks should be in a slight v instead of being plumb up down. The span from rail to rail is about 1 2 3 4 off but i guess that should be okay. Garage door shifts to one side. There are of course many other problems that can keep your garage door from functioning properly.

Bent tracks on your garage door need immediate repair to get the door working properly. Thanks for the quick response. The track should be tighter at the bottom then at the top if it is tight enough at the bottom the door will always close in the same position. Yeah that was it.

One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door. Your door has simply shifted to one side. Push the door back to adjust the door and get the center aligned again. Most track damage happens to the vertical tracks that attach to the wall of the garage door opening.

Click on a problem below to see the possible causes and solutions. If you ve had your door for a while or are in and out of it a lot it can easily end up out of alignment. Maybe someone bumped into it recently. The door runs are housed in a garage door track one on each side of the garage door.

By pushing the door back into position you should have made the vertical track straighten. Or it could just be that the hardware has become loose over time.